- Title: Member
- Status: Offline
- Registered: 12/10/2008
- Posts: 60
Topic: Voltage on acid chloride zinc bath
I have read an article that says that the voltage used on acid chloride zinc bath must not be over 8 beacuse anode baskets corrode
two questions
1 it is the same for nickel?
2 it does apply for barrel plating ?
Last edited by Daniel (04/24/2010 - 01:11 AM)
- Title: Member
- Status: Offline
- Registered: 11/13/2007
- From: Charlotte, NC
- Posts: 316
Re: Voltage on acid chloride zinc bath
I've never had a problem using a high voltage in my nickel baths, both rack and barrel. The biggest problem with the baskets dissolving is when the nickel anode material gets too low. I would suspect that the same thing applies in acid chloride zinc.
-Dustin Gebhardt, CEF
Advanced Manufacturing/Finishing Engineer
Moen
Sanford, NC
Posts [ 2 ]
Guest posting is disabled. You must login or register to post a reply.